The Prescription—Quickdraw Unclipped
-
My climbing partner (31) and I, Alec Gilmore (29), went sport climbing at Pilot Mountain State Park in March 2023. I have ten years of climbing experience, and my partner has six, and we both take pride in our risk assessment and careful approach. The first route we planned to climb was occupied, so we found a nearby route that neither of us had previously tried. We incorrectly identified the route as a 5.7. The route was actually Goodness Gracious (5.10a). I quickly realized the route was harder, but I had previously led up to 5.11 here, so I went on and clipped three bolts and then hung to work out the crux. It involved throwing a high heel hook and manteling onto an awkward bulge.
I got partially over the bulge and needed to make one more move but couldn't find a good handhold. I ended up falling off. Instead of stopping, I hit the ground after falling 20 feet. Both feet landed on a flat rock step on the main hiking trail. My belayer took up enough slack so that the rope started to catch right as my feet hit. After lying on the ground, overcoming the initial shock and pain, I realized that the alpine quickdraw that I had clipped into the third bolt was still clipped to the rope. Somehow as I was wrestling with the move, it had come unclipped from the hanger. I was wearing a helmet, but fortunately I did not hit my head or back during the fall.
Park staffers were alerted by a nearby climber, and in about 30 to 45 minutes a team of park employees, other climbers, and volunteers arrived and loaded me onto a transport basket. For the next hour and a half, they carried me back up to the summit, where an ambulance was waiting. At one point they rigged a rope and hauled me up a steep hill to shorten the journey. At the hospital, X-rays showed I had fractured both heel bones. One of the fractures was bad enough to require surgery, and I received a plate and four screws.
The first mistake we made was not being sure of what route we were climbing. We had recently been trying routes we hadn't previously climbed. The route I fell from was on my to-do list, but the plan was to warm up with an easier route.
The second mistake was the positioning of the carabiner on the bolt hanger. I knew that it was possible for a carabiner to unclip from a bolt hanger if it's pulled up against the wall in a certain way. I try to keep the spine of the carabiner pointed in the direction I'm climbing. When I was clipping the third bolt, I thought I would climb toward the left side of the bulge. The line turned out to go right. Somehow, as I wrestled with the move, the quickdraw came unclipped.
Though rare, carabiners can come unclipped from bolt hangers. A few things to consider: The hanger-clipping-end carabiner should be loose in the sling, never held by a rubber keeper. Both carabiners on a quickdraw should be oriented with the gates facing the same direction. As Alec mentions, quickdraws should be clipped so the gates are oriented away from the direction of travel.
The direction in which one clips also can be a factor in certain cases. Clipping the opposite direction from the angle of the carabiner hole will minimize the possibility of the carabiner levering against the hanger and unclipping. Almost all plate-style bolt hangers have the clipping section on the left side of the hanger. So, the ideal clipping direction would be from left to right. Other factors (like the ones mentioned above) may be more important in a given situation, but when you have a choice, this is the preferred method.
For even more security, a safer play is to flip the gate so it opens downwards. Better yet, if the clip is critical, i.e. before or after a runout, use a locking carabiner on the hanger end of the quickdraw.(Source: Alec Gilmore and the Editors.)
Under some circumstances, quickdraws can unclip themselves. Editor of Accidents in North American Climbing, Pete Takeda, and IMGA/AMGA Guide Jason Antin, are back to show you that clipping bolts isn’t always as simple as it seems. Dive in to get the accident analysis informing these takeaways, and some quick tips on how to mitigate risk when clipping bolt hangers.
Credits:
Pete Takeda, Editor of Accidents in North American Climbing, and Jason Antin @jasonantin, IFMGA/AMGA Certified Mountain Guide; Producer: Shane Johnson; Cinematographer or Videographer: Foster Denney; Editor: Sierra McGivney; Location: Accessibility Crag, Clear Creek Canyon, CO; Presenting Sponsor: Rocky Talkie @rockytalkies.
The Prescription—Quickdraw Unclipped — American Alpine Club
Fall on Rock | Quickdraw Unclipped from Bolt Hanger North Carolina, Pilot Mountain State Park My climbing partner (31) and I, Alec Gilmore (29), went sport climbing at Pilot Mountain State Park in March 2023. I have ten years of climbing experience, and my partner has six, and we both tak
American Alpine Club (americanalpineclub.org)
-
Awhile back I tried to do this on my practice belay setup in my garage but it's exceedingly hard to do reliably.
It's one of those one-in-a-thousand circumstances that inform our choices as climbers.
A very good tip included was to use a locker on the bolt-end (or rope end too, if you wish) on crucial draws, like before cruxes and after run-out sections.
Similar discussions on other sites always suffix that with "even though I get laughed at for doing it", but safety is no joke!
